Warped Table Mold

$690.00

Warped Table Mold. Warped? you ask. Yes thanks to Trinic’s unique admixtures we have developed a way to “Warp” or bend concrete! This mold can be used with a jig to produce a unique table that has a nice flowing curve at each end producing a one piece table with a sleek, slender modern look.

This mold can also double as a flat table or accent wall panel when cast flat.

Use Trinic’s integral color and/or Versa Color to add your unique personal touch!

Weight: 60# Dimensions: 97″ X 24.5″ X .75″

Description

Warped Table Mold. Warped? you ask. Yes thanks to Trinic’s unique admixtures we have developed a way to “Warp” or bend concrete! This mold can be used with a jig to produce a unique table that has a nice flowing curve at each end producing a one piece table with a sleek, slender modern look.

This mold can also double as a flat table or accent wall panel when cast flat.

Use Trinic’s integral color and/or Versa Color to add your unique personal touch!

Weight: 60# Dimensions: 97″ X 24.5″ X .75″

Price is for the rubber mold only. contact Trinic for information on building your own jig for bending concrete.

Estimated life span with proper care = 1,000

Suggested mold release = Wax / Poly Ease/ Vaseline and mineral spirits (remove residue and clean mold after use to prevent degradation)

Composition = 74-45 urethane

USING THE MOLD:
Typically, no release agent is necessary when casting
plaster or wax in Poly 74-Series molds. For casting plaster: sponge, dip or
spray the mold with Pol-Ease® Mold Rinse and then pour plaster on the
wet mold to reduce air bubbles in the plaster and aid release.
For casting concrete, use a form release, such as Wax, Pol-Ease® 2300, 2650 or 2601.
Avoid solvent-containing releases since they can cause mold distortion
(i.e., shrinkage or swelling).
After repeated casting with certain resins, plaster and concrete, molds
may shrink slightly since these materials extract oils from the mold. The
proper selection of release agent and/or barrier coat can minimize this
effect. If shrinkage becomes evident, a light application of Pol-Ease® Mold
Dressing can help to restore the mold to its original dimensions.
Poly 74-Series molds last many years if stored undistorted on a flat, non-
porous surface in a cool, dry location out of direct sunlight. If occasional
outdoor use is required, add 0.5% UV Additive to the total mix weight to
reduce the characteristic surface degradation caused by sunlight. Never
store Poly 74-Series molds outside as UV exposure will eventually degrade
the rubber.
1

Start typing and press Enter to search