Trinic Stamp Shield is specifically designed for use on Stamped concrete, pavers and natural stone to provide stain protection by penetrating and chemically reacting with the natural materials found in concrete and stone.
Permanent part of the surface • Will not chip or peel • Resistant to all common staining agents• Easy application • Color enhancing • Thin build high performance
Surface must be clean, free of dust, dirt, mildew, oil, grease, paint, sealers, curing agents, waxes, and surface contamination. An extremely dense surface is required for proper performance.
Professional use only product. Trinic STAMPSHIELD can be brushed or rolled but for best results and to avoid over application it is recommended to be sprayed on using a high quality pump up sprayer with Viton seals and a fine to medium tip. Application rates vary from 400 sq ft. / gallon on re-seals and power troweled concrete to 150 sq ft. / gallon on porous concrete.
It is important to not over apply STAMPSHIELD so that it remains breathable; the best way to ensure correct application is to apply two thin coats. First coat should color enhance most of the surface but leave no shine. The second coat will even out the surface to a uniform color enhanced look with no to a very slight sheen.
- Color enhanced surface without thick plastic looking build
- Remains breathable will not white out from trapped moisture
- UV stable will not turn yellow
- Will not chip or peel
- Can be used for rejuvenating existing solvent based sealers.
- Can be applied to a damp surface (no standing water)
- Application temps between 35F—95F
Water proof in 10 minutes • Walk able in 20-30 minutes • Traffic in 2 hours.
Liquid Properties (General)
Appearance (cured) – Clear sheen
Water Resistance – Excellent, beads water
Mechanical Stability – Excellent
Light Stability – Excellent UV exposure shows no degradation
Diluent – Acetone and other exempt solvents
Storage Stability – 2 yrs.
Appearance (wet) – Clear slightly opaque
Odor – Acetone
Application Temperature – 35F – 95F (surface temperature)
Blush: 4 hr. dry / 24 hr. immersion does not blush
Adhesion: D-33598 Excellent
Water Beading:Beads water
QUV G-53 250 hrs. : no blistering, no yellowing
Abrasion Resistance: D-460 20 mg loss
Chemical Resistance (12 hour covered) D-1308-87:
Transmission fluid: No– Effect
Gasoline: Softens – recovers
Formula 409: No-Effect
Motor oil: No-Effect
Brake fluid: Softens, recovers
10% Hydrochloric Acid: No-Effect
10% Sulfuric Acid: No-Effect
Red Wine: No-Effect
Vinegar: Blemish/ repairable
Pencil Hardness: D-3363 6H
Hot Tire Pick-up: Passed
- Item #: Trinic Stamp Shield (5) Gal